美国omega PRTX69变送器
通用智能变送器 TX69 通用智能变送器 高精度 LED显示积分 输入：T / C，RTD，Ω，与M galvanic隔离 配置和calibrations是基于PC的软件（它需要的P / N的USB电缆tx69电缆单独出售）
The TX69 is a digital, PC programmable, galvanic isolated two-wire smart transmitter, that converts 13 types of thermocouple sensors; 12 types of RTD sensors, configured as 2, 3 and 4 wires; potentiometer, resistor and millivolt inputs, single or differential.into process current loop. A 3 1/2 digit LED display is integrated forming a transmitter/field monitor unit which is visible in dark installations. A 24 bit A/D converter is the heart of the outstanding performance. The light intensity varies as a function of the current loop, which serves as the light energy source. The transmitter can be set and wired to perform differential measurement conversions of temperature sensors as well as mV sources. The output current is temperature linearized and can be set to be 4 to 20/20 to 4 mA.or any range within these limits. The current is limited to 3.6 and 22 mA. The TX69 samples and updates the output current in a rate of 2 to 4 samples per second depending on the sensor type. It is fully configurable in dry-configurationTM mode by which the connection to PC is performed with no voltage needed, and the configuration parameters are stored in a non-volatile memory. Exceptional digital accuracy of typical ±0.1°C is provided for most sensors regardless of the calibrated span. Extremely accurate coldjunction temperature measurement provides precise compensation throughout the entire ambient range. Detection of sensor breakage or disconnection of input leads, forces the output to a pre-defined up/down scale value. The unit continuously monitors the sensor and automatically returns to normal operation mode when the sensor is recovered. The TX69 is housed in Aluminum enclosure, and the front panel has a special red filter for optimal view. 规格 Input Input Impedance: >107 Ω: Maximum Input Voltage: <1V Output Output Signal: Proportional dc current 4 to 20 mA or 20 to 4 mA (user configurable) Under Range: Linear to 3.97 mA Over Range: Linear to 20.8 mA Burnout: < 3.6 mA or > 22.1 mA (user configurable) Isolation: >1500V between input and output Output Linearity: For Temperature Sensors: Linear with temperature For Potentiometer: Linear with potentiometer ratio For Millivolt Input: Linear with the measured voltage Long Term Stability: < ±0.1 % of span for 12 months Maximum Loop Resistance: According to: Rmax(Q) = (Vsupply-8.5)/0.02 Calibration Accuracy: At 24V supply, at room temperature: 0.05% (*) Damping Factor: 1 to 100 seconds Analog Step-Response: 200 to 500 mS (depends on the sensor and the mode of operation) Set-Up Time: 5 seconds after power on Supply Supply Voltage: 13 to 36 Vdc Supply Variation Effect: Negligible (<11.1AN) Polarity Protection: Yes CMR: >110 db Environmental Influence Operating Temperature Range: -40 to 80°C (-40 to 185°F) Storage Temperature Range: -50 to 90°C (-45 to 185°F) Temperature Stability: < ±0.004%/1°C (*) Humidity: 10 to 90 % RH, non condensing Housing Material: Aluminum Screw Connection: ?, & M20x1.5 Weight: 750 gr Programming Software Package: CONCAL Modem Cord: USB cable (1.5 m L) with 3.5 mm stereo plug Configured Parameters: Tag information, sensor type, input range, selection of connection type, output offset, output curve correction, damping factor, burnout type, output current mode, sensor calibration Thermocouple and Millivolts Type Input Range °C Input Range °F Minimum Span °C (°F) Digital Accuracy D/A Accuracy B 100 to 1820 212 to 3308 200 (360) ±0.5°C ±0.02% E -200 to 1000 -328 to 1832 50 (90) ±0.1°C J -200 to 1200 -328 to 2192 50 (90) ±0.1°C K -200 to 1370 -328 to 2498 50 (90) ±0.1°C L -190 to 890 -310 to 1634 25 (45) ±0.1°C N -200 to 1300 -328 to 2372 25 (45) ±0.1°C R 0 to 1760 32 to 3200 200 (360) ±0.5°C S 0 to 1760 32 to 3200 200 (360) ±0.5°C T -200 to 400 -328 to 752 50 (90) ±0.1°C U -190 to 590 -310 to 1094 25 (45) ±0.1°C D 0 to 2230 32 to 4046 25 (45) ±0.5°C G 0 to 2160 32 to 3920 25 (45) ±0.5°C C 15 to 2320 5 to 4208 25 (45) +0.5°C Millivolt Input -145 to 145 2 mV ±51 uV Mode T/C: Single or differential sensor Voltage: Single or differential ended Cold Junction Internal Pt-100 sensor C.J. Accuracy ±0.5°C (±0.9°F) Sampling Rate T/C: Single: 4, Differential: 2 (S/sec) Voltage: 4, Differential: 2 (S/sec) Note: For maximum accuracy for T/C input, all the above error components should be accumulated. 注释: Comes with complete operator’s manual and software.
产品型号/产品描述 TX69 Universal Smart Transmitter (TX69-CABLE is required to scale unit) PRTX69 Industrial Cast Iron Head,12 inches long, 1/4 inch diameter,100 Ohm Pt 3-wire configuration, 304 SS sheath with TX69 transmitter NB1TX69-(*) Industrial Cast Iron Head,12 inches long, 1/4 inch diameter, ungrounded junction, 304 SS sheath with TX69 transmitter . (*) specify J, K, T or E only. TX69-CABLE Communication cable for model TX69 and TXDIN101 PSR-24L Regulated power supply, 24 Vdc, 400 mA, stripped leads, UL
粤公网安备 44030402001379号
