JY4010型电液比例阀控制器(双比例)
一、概述
JY4010型电液比例阀控制器是一种专门为注塑机设计的比例功率放大器，
可分别对力士乐、威克斯、油研、台湾东锋和机立等厂家的各类电液比例阀
进行压力和流量的控制。其性能稳定、可靠性高，组成主要包括：
稳压器
斜坡发生器
输入值预调电位器
500HZ正弦振荡器
可控恒流发生器
二、技术数据
电源电压（V）：AC 24?∽36V±10%
功 耗（P）：*大80VA
控制电压（U）：±9V
控制电压*小负载电阻（R）：500Ω
*大输出电流（Imax）：800mA
*大负载电阻（R）：45Ω(对应*大电源电压)
先导电流（ID）：0∽200mA
颤振频率（F）：500Hz
环境温度（T）：0∽45℃
温 度 漂 移 :1‰(OF Imax)/ ℃
外 型 尺 寸 :160×110×50(mm)
三、主要功能：
通过外部电位器遥控调节
拨码开关数码控制
斜坡上升、下降时间0.1∽5秒可调
JY4010 type electrohydraulic proportional valve controller (doubleratio)
A, this
JY4010 type electrohydraulic proportional valve controller is aspecial design for injection molding machine the proportion ofpower amplifier,
Respectively to rexroth, wicks, oil research, Taiwan east fengand machine etc all kinds of manufacturer electrohydraulicproportional valve
Pressure and flow control. Its stable performance, highreliability, composed mainly include:
stabilizer
Slope generator
The input value of pre-mixed potentiometer
500 HZ ac sinusoidal oscillator
Controllable constant current generator
Second, technical data
The power supply voltage (V) : AC 24? ∽ 36 V + 10%
Power consumption (P) : the biggest 80 VA
Control voltage (U) : + 9 V
Control voltage minimum load resistance (R) : 500 Ω
Maximum output current (Imax) : 800 mA
Maximum load resistance (R) : 45 Ω (corresponding maximum powersupply voltage)
Leading current (ID) : 0 ∽ 200 mA
Flutter frequency (F) : 500 Hz ac
Environmental temperature (T) : 0 ∽ 45 ℃
Temperature drift move: 1 ‰ OF the Imax) / (℃
The type of feet inch: 160 x 110 x 50 (mm)
Three, the main functions:
Through the external remote to adjust potentiometer
Dial the code switch digital control
Slope of rise and fall time 0.1 ∽ 5 seconds can be adjusted